IT Knowledge Base

Technical Repository

HowTo: Configure SNMP on Linux

Just copy and paste the following commands in the terminal. They will update the configuration file and restart the service. Enable SNMP to listen on all interfaces sed -i ‘s/agentAddress udp:127.0.0.1:161/#agentAddress udp:127.0.0.1:161/g’ /etc/snmp/snmpd.conf Change SNMP Community String sed -i ‘s/ rocommunity public default -V systemonly/rocommunity MYSECURESNMPSTRING default -V systemonly/g’ /etc/snmp/snmpd.conf Allow SNMP connectinos from this […]

Read More


HowTo: Copy files between Cisco ASA’s in a cluster

Setup a TFTP server and copy the files that you want to copy to the failover device. This will execute the command on the remote failover firewall. failover exec mate copy /noconfirm tftp://192.168.1.10/asdm-731-101.bin disk0:/asdm-731-101.bin

Read More


HowTo: Add multiple IP’s to Exchange Receive Connector CLI

Return the list of IP’s from the connector: Get-ReceiveConnector “Relay Connector” | fl RemoteIPRanges Add a single IP address to the Connector. We pull the list of existing IP’s and append the new IP and then add the entire list back. $RecvConn = Get-ReceiveConnector “Relay Connector” $RecvConn.RemoteIPRanges += “10.0.0.99” Set-ReceiveConnector “Relay Connector” -RemoteIPRanges $RecvConn.RemoteIPRanges Read […]

Read More